Arrow Storage Products Mountaineer Series Owner's Manual & Assembly Manual page 12

Step 1: Trusses
You will need for this page:
LS SB
(QTY: 12)
(QTY: 24)
Washers are to be used on painted parts only. Washers
are not necessary on unpainted parts and there are
not enough to use on every Screw and Bolt.
10641
10642
10641
10642
Leave top holes open.
Build two Assemblies.
10641
Truss Post Insert fi ts INSIDE
10642
Truss Post as shown.
2
10641
Truss Post
1 Align the bottoms of the Truss Post and Truss
Post Insert and join as shown. Insert Large
Screws along both sides of the Truss Post
where holes align.
2
LS
Repeat instruction 1 to build a second Truss
Post Assembly. Set aside for use on next
page.
LS
10643
10644
LS
2
10642 10643
Truss Post Upper Chord
Insert Truss
With the Upper and Lower Chord Trusses
3
positioned as shown below, attach Shear
Plates where indicated below. Attach Shear
Plates using Small Bolts and Nuts to Upper Chord
fi rst, then to the Lower Chord. Do not tighten at this
time.
4
Repeat instruction 3 to build a second Chord
Truss Assembly. Set aside for use on next
page.
7004
7003
SB
Build two Assemblies.
Holes must align in this direction.
10643
10644
10643
10644
12
2 2
10644 7003
Lower Chord Left Shear
Truss
SB
7003
SB
Not this direction
4
Plate
4
7004
Right Shear
Plate
SB
7004