Arrow Storage Products Mountaineer Series Owner's Manual & Assembly Manual page 27

Step 9: Continued
You will need for this page:
SS SB
(QTY: 16)
(QTY: 2)
8576
Leave two holes open on each side of the Gable peak to attach Track Support.
Attach Gable to holes closest
to the Outside of the building.
SB
6228
Install Track Support.
1
9009
Gable Brace
Gable must fi t UNDER Side Wall Angle at corner.
10'x10' (3,0 m x 3,1 m)
building shown.
Inside
Rear Wall
SS
SS
2
6228
Track Sup.
SS
8577
2
Gable should be attached using the row of
holes closest to the outside of the building. Do
not insert screws into the two holes closest to
where the Gables join. These will be used to
attach the Track Support later.
3
through the second hole from the bottom only.
Gable
Outside
10629
Attach Brace with Bolt thru
second hole from bottom only.
4
Secure to Rear Frame using two Small
Screws.
27
Working with one Gable at a time,
attach the Gables to the top Rear
Frame with Small Screws. The
To secure Gables together, position
the Gable Brace as shown below and
insert a single Small Bolt and Nut
Position Track Supports as shown.
Secure Track Supports to Gable
using one Small Bolt and Nut.
9009
SB