Floor Plans - Labomed AXIUS User Manual

Installation
(continued)
CAUTION
Improper installation
Injury and damage

After the installation, check the support system for secure footing and ability to bear load.

5.6 Floor plans

Using the Paper template provided,
mark the positions of the three
mounting holes on wooden
membrane.
Drill three 1/4"(6mm) pilot holes
either direct into Joist or the
additional wooden membrane as per
the roof available.
Tighten all the bolts using Allen key
10mm.
C
Room without
inserted ceiling
Using the Paper template provided,
mark the positions of the three
mounting holes on wooden membrane.
Drill three 1/4"(6mm) pilot holes
either direct into Joist or the additional
wooden membrane as per the roof
available.
Tighten all the bolts using Allen key
10mm.
Inserted ceiling with cutout
Floor Perfora on
Drill the three mounting holes 14mm
diameter and 100mm deep.
Place a 10mm flat washer and a split washer
over each of the three M10 X 75 hex head
RAWL Plug.
Tighten all the bolts with 10mm allen key.
Axius
Room With Inserted ceiling
Contour Cap
Axius
External Contour cap
View from below of the room
ceiling (without inserted ceiling)
Installa on plan and drill template
Cutout contour of the inserted ceiling
External contour cap
24
Part No: 6137120-795
Issue: 1.0
Printed On: June 10, 2023