Pm/Yield Parts Settings; Replacement Procedure Of The Pm/Yield Parts - Ricoh MP C307 Field Service Manual

PM/Yield Parts Settings

PM/Yield Parts Settings

Replacement Procedure of the PM/Yield Parts

There are two ways to reset the PM counter for this machine.
•
Method 1: Reset by SP3-701 (New Unit Detection). This is the conventional method
•
Method 2: Reset by [PM Counter / New Unit Set] Menu
Method 2 is recommended for its ease of operation.
For the following units, there is a new unit detection mechanism. It is not necessary to reset PM counters.
•
Fusing unit
•
PCDU
•
Waste toner bottle (When the bottle is replaced AFTER a waste toner full or near-full message appears
on the operation panel)
Method 1: By SP3-701 (New Unit Detection)
1.
Enter the SP mode.
2. Output the SMC log data using one of the following ways:
a) Execute SP5-990-001 to print SMC log data.
b) Execute SP5-992-001 to save SMC log data to an SD card. (Refer to
You can print out the PM counter list as follows.
1. In the SP mode menu, press [PM Counter / New Unit Set].
2. Press [Counterlist print out].
170
"SMC List Card Save Function")