Table of Contents
Advertisement
WLAN
Modulation
Technical data of
General data
surge protective
Continuous operating current (I
device DC SPD
type 1+2 GEN24
Rated discharge current (I
- 15 x 8/20 µs pulses
Lightning surge current (l
Max. discharge capacity @ 10/350 µs
Protection level (U
(star-shaped mounting)
Short-circuit strength PV (I
Disconnector
Thermal disconnector
External fuse
Mechanical properties
Disconnection indicator
Remote communication of the con-
nection interruption
Housing material
Test standards
Explanation of
1)
footnotes
2)
3)
4)
5)
6)
7)
)
n
)
imp
)
p
scpv
The values stated are defaults; the inverter is configured specifically to
suit the requirements of the relevant country.
Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive).
Maximum current from a defective PV module to all other PV modules.
From the inverter itself to one PV side of the inverter, it is 0 A.
Guaranteed by the electrical configuration of the inverter.
For backup power mode (PV Point) without battery, a minimum voltage of
150 V is required.
Current peak when switching on the inverter.
The sum of the rated power per phase must not exceed the rated power of
the inverter.
802.11b: DSSS (1 Mbps DBPSK,
2 Mbps DQPSK, 5.5/11 Mbps CCK)
802.11g: OFDM (6/9 Mbps BPSK,
12/18 Mbps QPSK, 24/36 Mbps 16-
QAM, 48/54 Mbps 64-QAM)
802.11n: OFDM (6.5 BPSK, QPSK,
)
cpv
)
Mechanical indicator (red)
Output on the changeover contact
Thermoplastic UL-94-V0
IEC 61643-31 / DIN EN 50539-11
UL1449 ed.4 / VDE 0185-305-3 Bbl.
16-QAM, 64-QAM)
< 0.1 mA
20 kA
6.25 kA
4 kV
15 kA
Integrated
None
5
189
Advertisement
Table of Contents
