Western Digital Ultrastar Data60 Manual page 17

EcoDesign Disclosures
Figure 15: Removing IOM
Step 14 : Repeat these steps to remove the remaining IOM from the enclosure.
Disassembling the IOMs
Lay one of the IOMs on its side.
Step 15 :
Step 16 : Using a T7 Torx screwdriver, remove the four (4) M3 6mm screws from the ends of the IOM:
Lift the bottom edge of the side-panel. Then slide the panel toward the bottom of the IOM before
Step 17 :
lifting it upward to remove it from the IOM:
1. EU EcoDesign Disclosures
1.4 Ultrastar Data60 Disassembly
13