Ck34-R500 Rock Kit Installation - kozy heat CSK-34-R Installation And Operation Manual

9.2 #CK34-R500 Rock Kit Installation

CAUTION: Do not place rocks directly over burner port holes.
Improper rock placement may affect flame appearance and
cause excessive soot to build upon the rocks and glass.
NOTE: Rock numbers are located on the bottom on of each
rock. Follow the instructions and illustrations below.
• Remove refractory panels (if used or desired), the burner
tube, and the back log plate.
1. Optional: Install (3) porcelain panels.
2. Install the (2) rock brackets on the left and right side of the
burner.
3. Install the rock plate at the back of the firebox. Refer to
Figure 9.2, Removed Log Plate
Figure 9.3, Installed Rock Plate and Brackets
Figure 9.4, Rock Set Installation
Figure 9.5, Completed Installation
4. Reinstall the burner tube. Verify gasket is underneath.
5. Place the (8) spacers onto the pins on the burner. Tighten
with the nuts included with this kit using a 5/16" nut driver.
6. Align the holes in on the bottom each RX10 rock with the
pins on the burner, as shown in Figure 9.4. Push to seat.
7. Place rocks R6 and R1 over the burner tube as shown.
8. Place rocks R11 as shown in . Distribute rockwoll embers
onto burner and base rocks using a stiff bristle brush.
9. Place the rest of the rocks as shown in Figure 9.5. Distribute
additional rockwell embers once completed.
FIREPLACE INSERT SETUP 21