Table of Contents
Advertisement
9.0 GAS FIREPLACE INSERT SETUP
9.1 Glass Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
9.1.1 Remove Glass Assembly
WARNING: Do not remove the glass assembly when hot.
1.
Remove safety barrier.
1.
Locate (2) spring-loaded latches securing the glass assembly at
the bottom of the firebox.
2.
Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
3.
Lift glass assembly up and off of the (2) tabs located at the top of
the firebox.
9.1.2 Install Glass Assembly
1.
Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2.
Pull the spring-loaded latches out and up to secure the bottom
of glass to the bottom of the fireplace.
3.
Reinstall safety barrier.
SPRING-LOADED LATCHES
Figure 9.1, Glass Frame Assembly Installation and Removal
24
GAS FIREPLACE INSERT SETUP
TABS
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
9.2 Light Kit
CAUTION: Disconnect all electrical power from the fireplace before
performing this task.
ATTENTION: If converting to propane, complete the conversion before
installing any light kit components. Follow instructions provided with
the conversion kit (sold separately).
NOTE: To avoid damage and prolong the life of the halogen bulbs,
never touch with bare hands. Always use a soft cloth when handling.
9.2.1 Install Light Kit
1.
Remove (8) screws securing burner cover, then lift the cover out
of firebox.
2.
Loosen, but do not remove (4) screws securing light bars to
firebox floor. Slide light bars out away from screws, tipping
upwards to expose lamp bases.
3.
Install (6) halogen bulbs (included in components packet) into
lamp bases.
4.
Reattach light bars, securing with screws previously loosened.
5.
Reinstall burner cover, securing with screws previously removed.
Figure 9.2, Burner Cover Screws
Figure 9.3, Light Bar Screws (burner removed for clarity purposes only)
#CSK-34-G R.7 December 2018
Advertisement
Table of Contents
