Table of Contents
Advertisement
9.0 GAS FIREPLACE INSERT SETUP
9.1 Glass Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should
be done by a licensed or qualified service person.
9.1.1 Remove Glass Assembly
WARNING: Do not remove the glass assembly when hot.
1.
Locate (2) spring-loaded latches securing the glass assembly
at the bottom of the firebox.
2.
Pull the spring-loaded latches out and down to release the
bottom of the glass assembly.
3.
Lift glass assembly up and off of the (2) tabs located at the
top of the firebox.
9.1.2 Install Glass Assembly
1.
Align the slots on top of the glass assembly over the tabs at
the top of the firebox while lowering the bottom of the glass
assembly into position.
2.
Pull the spring-loaded latches out and up to secure the
bottom of glass to the bottom of the fireplace.
9.2 Light Kit
CAUTION: Disconnect all electrical power from the fireplace
before performing this task.
ATTENTION: If converting to LP (propane) gas, complete the
conversion before installing any light kit components. Follow the
instructions provided with the conversion kit (sold separately).
NOTE: To avoid damage and prolong the life of the halogen
bulbs, never touch with bare hands. Always use a soft cloth
when handling.
9.2.1 Install Light Kit
1.
Remove the safety barrier and glass frame assembly.
2.
Remove logs and refractory panels from fireplace (if
installed).
3.
Remove burner assembly (2) screws.
4.
Remove ember panel.
5.
Remove burner, secured with (2) screws at the back corners
of the firebox.
6.
Install (4) halogen bulbs (included in components packet)
into lamp bases.
7.
Reinstall the ember panel.
8.
Reinstall the burner and burner assembly.
9.
Place of crushed glass media (included with fireplace)
into ember media cavity in front of the burner assembly.
Verify glass media is one layer deep in front of the burner.
Randomly place klinkers on top of glass media.
10. Reinstall logs, refractory panels, glass frame assembly, and
safety barrier.
GAS FIREPLACE INSERT SETUP 21
Advertisement
Table of Contents
