Shroud Installation; Safety Barrier Installations - kozy heat CSK-34-R Installation And Operation Manual

8.2 Shroud Installation

CAUTION: Trim panels or surrounds must not seal ventilation
openings in existing fireplace that this appliance is installed in.
WARNING: The flow of combustion and ventilation air must not
be obstructed.
For shrouds #CK34-2740,
#CK34-A344, #CK34-CUS, and #CK34-ACUS.
1. Remove the upper hood by lifting up and out of the mounting
flanges.
2. Remove lower louver by lifting the louver out of the slots on
the mounting bracket.
3. Remove the glass assembly.
4. Align the mounting holes on the shroud to the corresponding
mounting nuts on the sides of the insert metal cabinet.
5. Secure with (4) truss head screws (provided).
6. Reinstall all components previously removed.
Figure 8.1, Upper Hood Removal
Figure 8.2, Lower Louver Removal
MOUNTING
NUTS
(2 EACH SIDE)
Figure 8.3, Mounting Nuts Location
#CK34-3044, #CK34-3346,

8.3 Safety Barrier Installations

1. Locate the (4) slots on the shroud (2 each side).
2. Align the tabs located on the back of the safety barrier with
the slots on the shroud.
3. Raise the safety barrier slightly into the slots and allow the
tabs to lower into position.
• To remove safety screen: lift the screen up and out of slots.
FACING AND FINISHING 19