Table of Contents
Advertisement
8.2 Shroud Installation
CAUTION: Trim panels or surrounds must not seal ventilation
openings in existing fireplace that this appliance is installed in.
Draft relief openings must not be covered or blocked.
WARNING: The flow of combustion and ventilation air must not be
obstructed.
1.
Remove glass frame assembly.
2.
Align leg section holes on the shroud to the corresponding
mounting nuts in mounting brackets on each side of the insert
metal cabinet.
3.
Secure with (4) phillips truss head screws (provided).
4.
Reinstall glass frame assembly.
Figure 8.3, Aligned Mounting Nuts and Brackets
24 FACING AND FINISHING
8.3 Upper Louver and Lower
Louver Installation
8.3.1 Upper Louver Installation
1.
Align the tabs in the upper louver with the corresponding slots
in the mounting flange located in the top air space.
2.
Push the upper louver back into position.
8.3.2 Lower Louver
1.
Align the tabs in the lower louver to the corresponding slots in
the mounting brackets located in the bottom airspace.
2.
Set louver down into position.
LOWER LOUVER
Figure 8.4, Upper Louver and Lower Louver Installation
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
UPPER LOUVER
#CSK-25 R.11 August 2020
Advertisement
Table of Contents
