Table of Contents
Advertisement
8.2 Shroud Installation
CAUTION: Trim panels or surrounds must not seal ventila-
tion openings in existing fireplace that this appliance is
installed in. Draft relief openings must not be covered or
blocked.
WARNING: The flow of combustion and ventilation air
must not be obstructed.
1.
Remove Glass frame assembly.
2.
Align leg section holes on the shroud to the corre-
sponding mounting nuts in mounting brackets on
each side of the insert metal cabinet.
3.
Secure with (4) phillips truss head screws (provided).
4.
Reinstall glass frame assembly.
Figure 8.5, Aligned mounting nuts and brackets
Hussong Mfg. Co., Inc.
NDK-29-i Report No. 22-815
8.3 Safety Barrier Installation
Locate the (4) slots on the glass frame (2 on each
side).
Align the tabs located on the back of the safety barri-
er with the slows on the glass frame.
Raise the safety barrier slightly into the slots and al-
low the tabs to lower into position.
•
To remove safety screen; lift the screen up and out of
slots.
Figure 8.6, Screen barrier installation
26
Rev. 2 — November 2022
Starting Serial Number: 22 N29i00001 45
Advertisement
Table of Contents
