Oce CS6410 Basic Operation Manual page 37

To load media on take-up reel
This section explains the procedure, taking in TENSION winding mode for instance.
Install a paper tube on the Océ CS6410's scroller and scroller fl ange.
1
Scroller
Flange stopper
Knob
(1) The flange spacer has teeth. Push it as far as
it will go.
(2) Match the flange stopper with the claw of
the flange spacer
(3) Tighten the knob to secure the flange
spacer and the flange stopper.
Remove the two screws and move the roll spacer to the center of the
media. There are three screwing positions.
Roll spacer
Flange spacer
3 1
2
Paper tube
Roll spacer:
The roll spacer prevents the paper tube
from bending at the center due to the
media weight.
Do not move this roll
spacer.
Paper tube
Insert the scroller into the paper tube,
determine the distance between the
media edge and the flange.
Flange
Paper setting
gauge
Rotate the handle clockwise as far as it
will go, and then secure the scroller at the
point.
Attach the paper
setting gaugeʼs
flange side to the
flangeʼs spoke side.
Handle
37