Oce CS6410 Basic Operation Manual page 71

Check your problem / How to clear media jams / When an error message is displayed / Out of ink while printing / The media was skewed.
/ Warning messages / Move the Printer / Replace a waste ink bottle / Install and replace an ink pack / Replace a spittoon case / Replace a
wiper blade
Although the Printer is in the print mode, printing does not start with "PREHEATING" displayed on
the operation panel.
Items to be checked
Room temperature
Aff ect of air fl ow
The transmitted data is not printed.
Items to be checked
ONLINE LED (fl ashing?)
Media jams occur frequently.
Items to be checked
Media type
Media loading
Obstructions in the carriage
path or the media path
Suction fan power
Heater temperature setting
Print quality is poor.
See Advanced Operation Guide.
Blank sheet appears.
Items to be checked
Print data
Raise the room temperature. (Recommended temperature: 20 to 25ºC)
If the air from the air conditioner or fan is blowing against the paper guide, avoid the
air fl ow (by changing air fl ow direction, orientation of the Printer, or the location of the
Printer).
Check the communication conditions to the host computer.
Check whether the media type setting matches the type of media loaded. See "To
print on other media" on page 46.
Install the media properly. See "To load media on the Printer" on page 30.
Remove any obstructions. See "How to clear media jams" on page 73.
If the suction fan power is not proper, reduce the power. See Advanced Operation
Guide.
If the heater temperature is not best set, lower the heater temperature. See Advanced
Operation Guide.
Check the current print data to confi rm that you sent the blank sheet's data.
Corrective measures
Corrective measures
Corrective measures
Corrective measures
71