Function Problem - Telescope Out Permanently Selected; Functions At Cutback - Power Module Current Limit; Functions Locked Out - Constant Data Version Improper; Functions Locked Out - Platform Module Software Version Improper - JLG T350 Troubleshooting Manual

Table of Contents

Advertisement

SECTION 2 - TROUBLESHOOTING BY FAULT MESSAGES

2.78 FUNCTION PROBLEM - TELESCOPE OUT PERMANENTLY SELECTED

Distress Lamp: 1
The ground telescope out switch was closed when the machine was powered. The switch could be accidentally held,
mechanically stuck, or electrically shorted.
Functions Disabled at Ground Only: Telescope Out
Step Pretest Instructions
2.78.1
2.78.2 Disconnect X033. Place key
switch in ground position and
pull the emergency stop
switch.
2.78.3 Remove X014.21.pin from
X014. Place key switch in
ground position and pull the
emergency stop switch.
2.78.4 Place key switch in ground
position and pull the emer-
gency stop switch.

2.79 FUNCTIONS AT CUTBACK - POWER MODULE CURRENT LIMIT

Distress Lamp: 4
The Power Module is approaching its thermal limit and must reduce output to continue operation. The Power Module LED is
Flashing 8 - Controller Hot.
ELECTRIC POWERED MACHINES ONLY
All Functions Operable, but output from power module is at reduced power
Possible Causes: 4.1.1, 4.1.39, 4.1.12

2.80 FUNCTIONS LOCKED OUT - CONSTANT DATA VERSION IMPROPER

Distress Lamp: 9
Ground Module detected that the Application's Constant Data Version did not match the version embedded in Constant
Data's Flash Structure. The control system may resume operation once the difficulty has been corrected
Functions Disabled: Lift Up, Lift Down, Swing Left, Swing Right, Telescope In, Telescope Out, Jib Up, Jib Down, Level Up,
Level Down, Front Left O/R, Front Right O/R, Rear Left O/R, Rear Right O/R, Set (Extend O/R), Stow (Retract O/R), Engine
Start, Engine Throttle Pull, Engine Throttle Hold, Engine Choke Pull, Engine Choke Hold
Possible Causes: 4.1.10

2.81 FUNCTIONS LOCKED OUT - PLATFORM MODULE SOFTWARE VERSION IMPROPER

Distress Lamp: 9
The Platform Module reported a Software Major Version that was not compatible with the rest of the system. The control sys-
tem may resume operation once the difficulty has been corrected.
Functions Disabled at Platform Only: Lift Up, Lift Down, Swing Left, Swing Right, Telescope In, Telescope Out, Jib Up, Jib
Down, Level Up, Level Down, Front Left O/R, Front Right O/R, Rear Left O/R, Rear Right O/R, Set (Extend O/R), Stow (Retract
O/R), Engine Start, Engine Throttle Pull, Engine Throttle Hold, Engine Choke Pull, Engine Choke Hold
Possible Causes: 4.1.13, 4.1.11
2-78
ADE Code: 2-3
Test
Is the switch mechanically
stuck?
Is fault "Function Problem -
Telescope Out Permanently
Selected"still present?
Is fault "Function Problem -
Telescope Out Permanently
Selected"still present?
Measured voltage at
X004.30 = Vbatt?
ADE Code: 4-2
ADE Code: 9-9
ADE Code: 9-9
T350 T500J
Result
Yes
No
Yes
No
Yes
No
Yes
No
Corrective Action
Repair or replace the switch
Go to step 2.78.2
Go to step 2.78.3
Possible Causes: 4.1.18
Go to step 2.78.4
Possible Causes: Short in Brown 14-2
wire
Possible Causes: Short in Brown 14-
2-1 wire, 4.1.10
Possible Causes: 4.1.10
3121203

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T500j

Table of Contents