User Fault Codes - JLG T350 Troubleshooting Manual

Ground Test
1. Position the Platform/Ground select switch to the
Ground position.
2. Plug the analyzer into the connector inside the
Ground control box.
3. Pull out the Emergency Stop switch. and Start the
engine.
4. The analyzer screen should read:
5. Use the arrow button to reach SYSTEM TEST. Hit
Enter. The analyzer will prompt you asking if you
want to activate the system test; hit Enter again to
activate.
3121203
6. Follow the flow path in Figure 9-6., System Test Flow
Chart - Ground Station Tests and go through the
component tests. Hit the ESC key during any part of
the test to return to the main menu without complet-
ing all tests or wait until all tests are complete. Dur-
ing the TEST ALL INPUTS sequence, the analyzer
allows control switches to be operated and shows if
they are closed (CL) or open (OP).

9.8 USER FAULT CODES

A single digit fault code blinks on the Platform and the
Ground control panel to signal the operator of a proce-
dure fault. These Codes are as follows:
1 --> Procedure (i.e., Did Not Close Trigger, Joystick Not
Centered, etc.)
2 --> Vehicle Setup (i.e., Outriggers Not Set, Machine Not
Level)
3 --> Battery Charger Engaged
4 --> Excessive Duty Cycle/Power Module Thermal Cutout
5 --> Batteries Discharged/Start Engine/Turn Off System
6 --> Not Used
7 --> Not Used
8 --> Not Used
9 --> Vehicle Requires Service
T350 T500J
SECTION 9 - JLG ANALYZER
9-212