JLG T350 Troubleshooting Manual page 121

Table of Contents

Advertisement

and Turntable2 should always be in opposite states. To reset the switch, lift boom till transport switch opens, then lower onto rest
again.
Step Pretest Instructions
3.5.1 Place boom on rest,
Check Analyzer -> Diag-
nostics -> Drive
3.5.2 Check Analyzer -> Diag-
nostics -> Drive
3.5.3 Check Analyzer -> Diag-
nostics -> Drive
3.5.4 Check Analyzer -> Diag-
nostics -> System
3.5.5
Hand Brake Position Sensor
If an error is detected with the switch, "HAND BRK SW ERR" is displayed in the diagnostics. As the hand brake is applied,
Brake1 should change from Off to On, and Brake2 should change from On to Off. Brake1 and Brake2 should always be in
opposite states. To reset the switch, cycle the hand brake.
Step Pretest Instructions
3.5.6 Apply hand brake, Check
Analyzer -> Diagnostics -
> Drive
3.5.7 Check Analyzer -> Diag-
nostics -> Drive
3.5.8 Check Analyzer -> Diag-
nostics -> Drive
3.5.9
3121203
Test
"TURNTBL SW ERR" dis-
played
"TURNTABLE1 ON" dis-
played
"TURNTABLE2 OFF" dis-
played
"TRANS LMT SW CL " dis-
played
Is boom on rest?
Test
"HAND BRK SW ERR" dis-
played
"BRAKE1 ON" displayed
"BRAKE2 OFF" displayed Yes
Is hand brake applied?
T350 T500J
SECTION 3 - COMPONENT CHECKS
Result
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Result
Yes
No
Yes
No
No
Yes
No
Corrective Action
Go to step 3.5.2
Switch is already reset
Go to step 3.5.3
Go to step 3.5.5
Go to step 3.5.4
Possible Causes: Orn/Red 59-1 wire
shorted, 4.1.18
Lift boom till transport switch
opens, then lower onto rest again to
reset the switch
Possible Causes: Bad transport
switch, see 3.17 Transport Limit
Switch
Possible Causes: Switch
obstructed, 4.1.20, Orn/Red 58-1
wire broken, 4.1.18
Place boom on rest and try again
Corrective Action
Go to step 3.5.7
Switch is already reset
Go to step 3.5.8
Go to step 3.5.9
Cycle hand brake to reset the switch
Possible Causes: Orn/Red 57-1 wire
broken, 4.1.18
Possible Causes: Switch
obstructed, Orn/Red 56-1 wire bro-
ken, brake cable broken, 4.1.20,
4.1.18
Place boom on rest and try again
3-121

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T500j

Table of Contents