Chassis Tilt Sensor Not Calibrated; Chassis Tilt Sensor Out Of Range - JLG T350 Troubleshooting Manual

SECTION 2 - TROUBLESHOOTING BY FAULT MESSAGES

2.12 CHASSIS TILT SENSOR NOT CALIBRATED

Distress Lamp: 9
The tilt sensor calibration has not been performed for the chassis tilt sensor. Tilt reading displayed as 90° and vehicle
assumed to be tilted.
Functions Disabled: Same as Tilted
Step Pretest Instructions
2.12.1

2.13 CHASSIS TILT SENSOR OUT OF RANGE

Distress Lamp: None
Tilt Sensor read angle greater than 19° for more than 4 seconds after 2 second power-up delay. Tilt reading displayed as
90° and vehicle assumed to be tilted.
Functions Disabled: Same as Tilted
Step Pretest Instructions
2.13.1
2.13.2
2.13.3
2-46
ADE Code: 8-1
Test
Has the tilt sensor calibration
been run?
ADE Code: None
Test
Is the machine tilted 19° or
more?
Is the ground module prop-
erly oriented and mounted?
Has a tilt sensor calibration
been run recently?
T350 T500J
Result
Yes
No
Result
Yes
No
Yes
No
Yes
No
Corrective Action
Possible Causes: 4.1.10
Run the tilt sensor calibration
Corrective Action
Level machine before operating
Go to step 2.13.2
Go to step 2.13.3
Properly secure the ground module
with the machine resting on a level
surface. Run the tilt sensor calibra-
tion
Possible Causes: 4.1.10
Properly secure the ground module
with the machine resting on a level
surface. Run the tilt sensor calibra-
tion
3121203