Drive & O/R Prevented - Operate From Platform - JLG T350 Troubleshooting Manual

SECTION 2 - TROUBLESHOOTING BY FAULT MESSAGES
2.20 DRIVE & O/R PREVENTED - OPERATE FROM PLATFORM
Distress Lamp: 2
In Platform Mode, an attempt was made to operate Drive or Outriggers, but X007.7 is not at Battery Voltage, as it should be
when the platform console is plugged into the platform position.
Using the JLG Analyzer, view the Platform Position status under DIAGNOSTICS -> SYSTEM. The vehicle must be in "AWP
MODE" (not "HOOK MODE") with PLTPOS1 +B and PLTPOS2 GND.
DRIVE OPTION MACHINES ONLY
Functions Disabled (Drive Option Machines Only): Drive
Step Pretest Instructions
2.20.1
2.20.2 Using the JLG Analyzer, view
the Platform Position status
under DIAGNOSTICS -> SYS-
TEM. The vehicle must be in
"AWP MODE" (not "HOOK
MODE") with PLTPOS1 +B
and PLTPOS2 GND.
2.20.3 With t he console in the plat-
form position, pull the ground
and platform emergency stop
switches and place key switch
in the platform position
2.20.4 With t he console in the plat-
form position, pull the ground
and platform emergency stop
switches and place key switch
in the platform position
2.20.5 Remove X058.K. With t he
console in the platform posi-
tion, pull the ground and plat-
form emergency stop
switches and place key switch
in the platform position
2.20.6 Remove X054.10. With t he
console in the platform posi-
tion, pull the ground and plat-
form emergency stop
switches and place key switch
in the platform position
2.20.7 Remove X019.10. With t he
console in the platform posi-
tion, pull the ground and plat-
form emergency stop
switches and place key switch
in the platform position
2-50
ADE Code: 2-5
Test
Is the platform console
plugged into the platform?
Is PLTPOS1 +B?
Is the voltage on X059.D.pin
= VBatt?
Is the voltage on X059.K =
VBatt?
Is the voltage on X058.K.soc
= VBatt?
Is the voltage on
X054.10.soc = VBatt?
Is the voltage on X019.10.pin
= VBatt?
T350 T500J
Result
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Corrective Action
Go to step 2.20.2
Connect the platform console at the
platform position and try again
Possible Cause: 4.1.10
Go to step 2.20.3
Go to step 2.20.4
Possible Cause:
Go to step 2.20.5
See 2.124 Platform Position Detec-
tion Faulty
Go to step 2.20.6
See 2.124 Platform Position Detec-
tion Faulty
Go to step 2.20.7
See 2.124 Platform Position Detec-
tion Faulty
Possible Cause: Orn/Red 49-10 wire
open or swapped with Orn/Red 49-9
wire.
See 2.124 Platform Position Detec-
tion Faulty
Possible Cause: Orn/Blk boom wire
open or swapped with Blu/Blk wire.
See 2.124 Platform Position Detec-
tion Faulty
3121203