JLG T350 Troubleshooting Manual page 182

Assembly
Check to be sure the wedge lock is in the open, or as-shipped, position (See Figure 7-6.). Proceed as follows:
1. To insert a contact, push it straight into the appropriate circuit cavity as far as it will go (See Figure 7-8.).
2. Pull back on the contact wire with a force of 1 or 2 lbs. to be sure the retention fingers are holding the contact (See Fig-
ure 7-8.).
3121203
Figure 7-6. Connector Assembly Figure 1
Figure 7-7. AMP Connector
T350 T500J
SECTION 7 - ELECTRICAL REFERENCE
7-182