Table of Contents
Advertisement
Leads are shown in white, can be distinguished easily from the original contours, and can not be selected
separately without the originals.
The picture below shows a different result on the same part with the option Change type, keep position
selected and the option Check leadline unchecked. In this result, the lead-ins are placed to the original start
positions of the contours and the lead-ins on the two small circles are longer than their radius, not corrected
automatically.
The option Type, Angle, Length and Radius specify the geometry of lead-ins and lead-outs.
Type
Description
None
Machining begins or ends directly on the contour without lead-in or lead-out.
Line
A straight line leads in to or out from the contour.
Arc
An arc leads in to or out from the contour.
Line +
A straight line and then an arc lead in to the contour, or an arc and then a straight line
Arc
lead out from the contour.
rev_0.6
89 / 135
Advertisement
Table of Contents
