Table of Contents
Advertisement
In case of co-edging the cutting paths generated by the kerf compensation function, the software will remove
the original contours automatically, as shown below.
You can also use the co-edge function when constructing a few parts for machining directly.
First, move the parts side by side with overlapped outlines, the software will help you on that when the object
snap functions are enabled, refer to
Object Snap Functions
for more information. Second, select the contours
and then select the command Coedge in Home.
A dialog will pop up if two and only two exact same rectangles chosen for co-edging. Different co-edge styles
result in different processing sequences. Otherwise, the operation will be completed silently.
rev_0.6
108 / 135
Advertisement
Table of Contents
