Table of Contents
Advertisement
CypCut has a set of commands for the group function, i.e. Group, DeGroup, Ungroup Selected, Ungroup
All, etc. Sometimes, you can use these commands when constructing a very complex part which has several
logical subsets of contours, where you can set up groups and make the editing a bit easier.
Select the contours and then select the command Group in Home, the software will set them up as a group.
Then the group will be kept selected and the command Group will be changed to DeGroup. Select a group
and then select the command DeGroup to break up the group.
When selecting several groups, you can still select the command Group to set up a group of the groups; or,
you can select the command Ungroup Selected in the pulldown-menu Home>Group to break up all the
selected groups. If you want to break up all the groups in the drawing window, please select the command
Ungroup All in the pulldown-menu Home>Group.
By the way, there is another command Explode in the pulldown-menu Home>Group, which is for breaking
up polylines created in the software when you want to make a change, different with the command DeGroup.
rev_0.6
105 / 135
Advertisement
Table of Contents
