Table of Contents
Advertisement
You can also set cooling points by hand. Select the command Cooling Point in Home, the cursor will appear
in a small dashed circle, and click on the contours to set cooling points until press the Esc key or select the
command Cancel Cooling Point in the context menu.
If you are not happy with the cooling points and want to make a change or just delete one or some of them,
press the Shift key when running the cooling point function, the cursor will appear in a small square, and click
on the cooling points you want to remove. And, you can select the command Clear Cooling Point in the
pulldown-menu Home>Cooling Point to remove all cooling points.
Ring Cut
The ring cut function adds extra travel paths on corners and the laser head will slow down then speed up
there out of corners, help improve the geometry precision and the quality of corners when cutting thin
materials in high speed.
Select the contours and then select the command Ring Cut in Home.
In the pop-up dialog, set the angle range of corners in the option Max angle, set the size of extra travel paths
in the option Min length and Extend length, check the option Laser off for ring paths if you want to turn
off the laser on the paths.
rev_0.6
101 / 135
Advertisement
Table of Contents
