Table of Contents
Advertisement
Option
Description
Pre-
Finish piercing of all or some of the parts before cutting.
pierce
Defilm
Burn off the protective film on the sheet along the cutting path before cutting.
Recool
Blow the assist gas along the cutting path after cutting to get a better cooling effect.
Multi-
Cut multiple times.
cut
Gas on
The assist gas will not be turned off in the whole process.
Not
The parts of this layer will not be cut.
cut
Not
The sensor will be turned off and the laser head will not follow the sheet while cutting.
follow
There are three cutting modes. With the Fixed height mode selected, the laser head will be
kept at an user set height while cutting. With the Out-plate mode selected, the laser head will
Mode
be kept at a pre-defined height and start following down to the sheet when it moves into the
range of the sheet while cutting.
You can set cutting parameters in the Cut tab.
Parameter
Description
The nominal cutting speed. The actual cutting speed is often lower than the nominal speed
Cut speed
due to the presence of acceleration and deceleration at the beginning, the end and the
corners of the cutting path.
Lift
The space between the nozzle and the sheet while traveling.
height
Nozzle
The space between the nozzle and the sheet while cutting.
height
Gas type
The assist gas for cutting.
Gas
Pressure of the assist gas, valid only for gases controlled via electrical regulator, e.g. O
pressure
Peak
The nominal laser power set in percentage. The actual laser power is often lower than the
power
nominal power when the power curve function is enabled.
Duty
Duty of the PWM control signal set in percentage.
cycle
Pulse freq
Frequency of the PWM control signal.
Focus pos
Position of the focus according to the tip of the nozzle.
rev_0.6
.
2
83 / 135
Advertisement
Table of Contents
