Table of Contents
Advertisement
Co-edge
In some cases, the software can put parts side by side, resulting in overlapped outlines, and get optimized
cutting paths by removing one pass of the overlap, save the laser-on time, make the cutting process more
efficient.
The software will manage to optimize the cutting paths when nesting if the automatic co-edge function is
enabled in the technology settings.
Check the option Auto Coedge to enable the function. Set the length range of the straight outlines of parts in
the option Min Coedge Length. Check the option Co-edge with different length if you want the software to
try to co-edge outlines in different length.
rev_0.6
106 / 135
Advertisement
Table of Contents
