Table of Contents
Advertisement
IMPORTANT
This step must be done in a CLEAN environment, and the laser head must be held in
HORIZONTAL while connecting. Otherwise, there might be dust going into the laser
head, and the upper protective lens might get dirty and would be broken by the laser
while cutting.
4. Set the laser head back onto the Z axis slider.
5. Set the connections back on the laser head.
6. Close the access panel of the laser head.
4. Set the covers of the drag chains and the access panels back on the machine.
5. Connect the cables to the fiber laser.
rev_0.6
135 / 135
Advertisement
Table of Contents
