Table of Contents
Advertisement
The first part is the lower half of the whole part.
The second part is the upper half of the whole part.
In this case, the default optimizations do not close the opening contour successfully, and the software split it
into two separate parts. In the same way, you should follow the steps in
Import into the Drawing Window
to
complete the importing, close the contour manually (refer to
Drawing Optimizations
for more information),
and then add it to the part library just as before.
Similarly, if the default optimizations do not remove duplicated or tiny drawing elements successfully, the
software will import them as separate parts as well. Then you should follow the same process to solve the
issues.
rev_0.6
57 / 135
Advertisement
Table of Contents
