Table of Contents
Advertisement
Button
Label
PT LOC
Back /
Forward
Blow
Follow
Shutter
Aiming
Laser
⇧
⇦ / ⇨
Z↑ / Z↓
rev_0.6
Function
If the job was interrupted accidentally, such as by a power failure, you can
use this function to bring the laser head back to the position where the job
stopped after the laser system up running again, and press the Start button
to resume the job.
After the job was paused, you can use these functions to move the laser
head backward or forward along the cutting path.
A toggle switch to test whether the assist gas is working properly.
A toggle switch to test whether the laser head can follow the sheet properly.
A toggle switch to activate or deactivate the fiber laser's internal main power
supply. The internal main power supply must be activated before the laser
being firing.
A toggle switch to turns the fiber laser's red dot pointer on and off. (On
some fiber laser models, the red dot pointer is turned on and off
automatically associate with the status of shutter.)
A toggle switch to start firing laser, and stop firing laser automatically when
the button is released.
To move the laser head around the cutting bed. To make it easier to use,
/
/
⇩
turn on the red dot pointer for a visual indicator of where the laser head is
moving.
To move the laser head up or down. It is usually used when doing laser head
maintenance.
36 / 135
Advertisement
Table of Contents
