Table of Contents
Advertisement
2. (For 6kW only) Set the Y axis drag chain and its related parts in place.
The Y axis drag chain and its related parts are removed and put on the cutting bed during shipping.
First, assemble the base of the Y axis drag chain on the left side of the machine, put the drag chain on
it, and fix the end of the drag chain. Second, assemble the X-Y intersection part on the left end of the
gantry, and fix the other end of the drag chain on it. Finally, tighten the cables, and pack up the section
of the cables out of the drag chain.
IMPORTANT
The cables are pre-set through inside the drag chain and the parts, which should be set up
carefully and gently to avoid damaging the cables.
rev_0.6
16 / 135
Advertisement
Table of Contents
