Table of Contents
Advertisement
Step 1.
Peel away the plastic and apply left latch cover to front latch of left rail.
Figure 105. Applying left latch cover
Step 2.
Peel away the plastic and apply one rail cover strip to bottom surface of left rail.
Figure 106. Applying left rail cover strip
Step 3.
Repeat the previous two steps on the right rail.
Cable the server
Attach all external cables to the server. Typically, you will need to connect the server to a power source, to
the data network, and to storage. In addition, you will need to connect the server to the management
network.
Connect to power
Connect the server to power.
Connect to the network
Connect the server to the network.
Connect to storage
Connect the server to any storage devices.
Power on the server
After the server performs a short self-test (power status LED flashes quickly) when connected to input power,
it enters a standby state (power status LED flashes once per second).
ThinkSystem ST650 V2 Setup Guide
148
Advertisement
Table of Contents
