Table of Contents
Advertisement
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Locate the flash power module slot on the air baffle.
Figure 92. Flash power module slot location
Table 42. Flash power module slot location on air baffle
Flash power module slot 1
1
Flash power module slot 2
2
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Install the flash power module.
ThinkSystem ST650 V2 Setup Guide
138
Flash power module slot 3
3
Flash power module slot 4
4
Advertisement
Table of Contents
