Table of Contents
Advertisement
Install the tower to rack conversion kit
This section includes instructions on how to install the tower to rack conversion kit.
Install the EIA brackets
Step 1.
If foot stands are installed on your tower server, lay the server on its side and remove them first.
a.
For each foot stand, rotate the foot stand inwards.
Figure 99. Adjusting foot stand
b.
For each foot stand, use a screwdriver to remove the screw that secures the foot stand; then,
remove the foot stand from the chassis.
Figure 100. Removing foot stand
Step 2.
Lay the server on its side; peel away the plastic and apply ruler label to rear corner of side cover as
shown.
.
Chapter 4
Server hardware setup
145
Advertisement
Table of Contents
