Table of Contents
Advertisement
Figure 96. Server cover installation
Note: Before you slide the cover forward, ensure that all the tabs of the cover engage the chassis
correctly. If all the tabs do not engage the chassis correctly, it will be very difficult to remove the
cover later.
a.
Lower the server cover onto the chassis until all tabs on both sides of the server cover
engage the chassis. Then, slide the server cover towards the front of the chassis until the
server cover stops and the front edge of the cover aligns with the edge of the front bezel.
b.
Use the key to turn the cover lock to the locked position.
Install the foot stands
Use this information to install the foot stands.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
.
Chapter 4
Server hardware setup
143
Advertisement
Table of Contents
