Table of Contents
Advertisement
Step 3.
Position the drive adapter with the drive into the 3.5-inch drive tray. Align the screw holes in the
drive adapter and the drive with the corresponding holes in the tray; then, install the five screws to
secure the drive adapter and the drive into the tray.
Figure 65. Installing the screws that secure the 2.5-inch drive and the drive adapter
Step 4.
Slide the tray with the drive into the drive bay from the front until it snaps into position and then
completely close the handle. See "Install a simple-swap drive" on page 109 or "Install a hot-swap
drive" on page 111.
Install a simple-swap drive
Use this information to install a simple-swap drive.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• For a complete list of supported optional devices for the server, see:
serverproven/index.shtml
https://static.lenovo.com/us/en/
.
Chapter 4
Server hardware setup
109
Advertisement
Table of Contents
