Remove The Front Vga Assembly - Lenovo 7X18 Maintenance Manual

Remove the front VGA assembly

Use this procedure to remove the front VGA assembly.
Before removing the front VGA assembly:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Remove the top cover (see
To remove the front VGA assembly, complete the following steps:
Step 1. Remove the fan cage assembly (see
Step 2. Disconnect the VGA cable from the system board.
Figure 53. Location of the front VGA connector on the system board
Step 3. Remove the four screws that fix the front VGA assembly.
55).
11).
"Remove the top cover" on page
"Remove the fan cage assembly" on page
"Safety" on page iii and
145).
.
Chapter 3 Hardware replacement procedures
"Installation
65).
71