Connect The Helix To The Wireless Dmx Signal Transmitter; Disconnect The Helix From The Wireless Dmx Signal Transmitter; Setup Example 1 - SHOWTEC Helix M1100 Q4 Mobile User Manual

Helix M1100 Q4 Mobile

Connect the Helix to the Wireless DMX Signal Transmitter

The Helix cannot actively match a random wireless signal transmitter.
In order to create a wireless match, please check the manual of your wireless signal transmitter.
We advise you to use the W-DMX BlackBox F-1 Tranceiver G6 (52001) by WIRELESS SOLUTION.

Disconnect the Helix from the Wireless DMX Signal Transmitter

01) Turn off/unlink the W-DMX. In order to do so, deactivate W-DMX (see 6.8.1.4. W-DMX Unlock on page
34 for more information).
02) Unlink the Helix (see 6.8.1.4. W-DMX Unlock on page 34 for more information).
03) The Helix will now be disconnected.

Setup Example 1

The Helix cannot send any wireless signals. Therefore, the slave Helix fixtures must always be connected
via a DMX signal cable.
Note:
The Helix M1100 Q4 Mobile is only a W-DMX receiver and never a W-DMX transmitter.
When the Helix operates in DMX or Slave mode, it can receive a wireless DMX signal (CH1–512) and at
the same time it can also send a DMX signal, via its DMX output (05), through a DMX cable.
Product code: 43750
26
Fig. 19