Table of Contents
Advertisement
Serial port
Allowed values are:
even
n
odd
n
none
n
The default is none.
4. Set the stop bits used by the device to which you want to connect:
(config)>serial port1 stopbits bits
(config)>
5. Set the type of flow control used by the device to which you want to connect:
(config)>serial port1 flow value
(config)>
where value is one of:
none
n
rts/cts
n
xon/xoff
n
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure RealPort mode using the Digi Navigator
You can configure RealPort mode for the Connect EZ using the Digi Navigator application. When you
install Digi Navigator on your computer, the RealPort application is automatically installed as well.
Each time the Digi Navigator is launched on your computer, any Digi devices that are on the network
and support device discovery are discovered by the Navigator.
For each of the devices that have been discovered, you can set all serial ports on the device to
RealPort mode, and then also enable the RealPort service. The COM ports on your laptop are also
configured. These processes ensure that RealPort is configured on the device and on your computer.
Operating system
The Digi Navigator can only be installed on a computer with a Windows OS. If you are using Linux, you
can manually install and configure RealPort without Digi Navigator. For the Linux installation process,
refer to the
Get started: Install RealPort for LINUX
Installation and configuration process
These steps explain how to install and configure the Digi Navigator.
Step 1:
Install the Digi Navigator
Step 2:
Configure RealPort on a Digi device from the Digi Navigator
Digi Connect EZ Mini User Guide
Configure RealPort mode using the Digi Navigator
in the RealPort Installation User's Guide.
149
Advertisement
Table of Contents
