Table of Contents
Advertisement
User authentication
TACACS+ user configuration
When configured to use TACACS+ support, the Connect EZ device uses a remote TACACS+ server for
user authentication (password verification) and authorization (assigning the access level of the user).
Additional TACACS+ servers can be configured as backup servers for user authentication.
This section outlines how to configure a TACACS+ server to be used for user authentication on your
Connect EZ device.
Example TACACS+ configuration
With TACACS+, users are defined in the server configuration file. On Ubuntu, the default location and
filename for the server configuration file is /etc/tacacs+/tac_plus.conf.
Note
TACACS+ configuration, including filenames and locations, may vary depending on your platform
and installation. This example assumes a Ubuntu installation.
To define users:
1. Open the TACACS+ server configuration file in a text editor. For example:
$ sudo gedit /etc/tacacs+/tac_plus.conf
2. Add users to the file using the following format. This example will create two users, one with
admin and serial access, and one with only serial access.
user = user1 {
name ="User1 for Connect EZ"
pap = cleartext password1
service = system {
}
}
user = user2 {
name ="User2 for Connect EZ"
pap = cleartext password2
service = system {
}
}
The groupname attribute is optional. If used, the value must correspond to authentication
groups configured on your Connect EZ. Alternatively, if the user is also configured as a local
user on the Connect EZ device and the LDAP server authenticates the user but does not return
any groups, the local configuration determines the list of groups. See
more information about authentication groups. The groupname attribute can contain one
group or multiple groups in a comma-separated list.
3. Save and close the file.
4. Verify that your changes did not introduce any syntax errors:
$ sudo tac_plus -C /etc/tacacs+/tac_plus.conf -P
If successful, this command will echo the configuration file to standard out. If the command
encounters any syntax errors, a message similar to this will display:
Digi Connect EZ Mini User Guide
Terminal Access Controller Access-Control System Plus (TACACS+)
groupname = admin,serial
groupname = serial
Authentication groups
for
530
Advertisement
Table of Contents
