Advertisement
Step 7
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw
and mounting screw to slide it against the stops. Then
tighten the mounting screw.
å
Fasten a DOOR (K) to the LEFT END (B) as shown
in the lower diagram. Use the screws in the HINGES.
You should start each SCREW a few turns before
completely tightening any of them.
å
Repeat this process fastening the remaining DOOR (K)
to the RIGHT END (A).
å
Push two DOOR STOPS (4I) into the holes in the
TOP (C) as shown.
K
The DOOR STOPS are
adjustable. If needed,
turn the DOOR STOPS
until they allow the
DOORS to evenly close.
Page 12
B
4I
Hinge
C
Stop
Mounting
screw
Adjusting
screw
A
Advertisement
