Download Print this page
Teknik 5426436 Manual

Teknik 5426436 Manual

Hythe wall mounted 4 shelf bookcase with door

Advertisement

Quick Links

www.teknikoffice.co.uk
Teknik
The stories of your life.
Hythe Wall Mounted 4 Shelf Bookcase with Door
5426436

Advertisement

loading

Summary of Contents for Teknik 5426436

  • Page 1 Teknik The stories of your life. Hythe Wall Mounted 4 Shelf Bookcase with Door 5426436...
  • Page 2 Table of Contents Assembly Tools Required Part Identifi cation No. 2 Phillips Screwdriver Tip Shown Actual Size Hardware Identifi cation Assembly Steps 6-17 Straight Edge Screwdriver Electric drill with 5/16" bit (ONLY in indicated step) Page 2...
  • Page 3 Now you know Part Identifi cation our ABCs. å While not all parts are labeled, some of the parts will have a label or an inked letter on the edge to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts. TOP (1) BACK (1) DOOR (1)
  • Page 4 Hardware Identifi cation å Screws are shown actual size. You may receive extra hardware with your unit. HIDDEN CAM - 6 CAM SCREW - 6 PULL - 1 WOOD DOWEL - 6 UPPER GUIDE - 2 LOWER GUIDE - 2 WALL ANCHOR - 2 L-WRENCH - 1 APPLIQUE CARD - 1...
  • Page 5 Hardware Identifi cation å Screws are shown actual size. You may receive extra hardware with your unit. 3/8" MACHINE SCREW - 2 1-9/16" PAN HEAD SCREW - 6 1-3/16" HEX HEAD SCREW - 8 1/2" FLAT HEAD SCREW - 8 1-15/16"...
  • Page 6 Hardware Usage Guide HOW TO USE A HIDDEN CAM & CAM SCREW OR CAM DOWEL NOTE: Various CAM SCREWS or a CAM DOWEL may be used. Turn the CAM SCREW or gently tap the CAM DOWEL until the shoulder is against the surface of the part.
  • Page 7 Step 1 Assemble your unit on a carpeted fl oor or on the empty å carton to avoid scratching your unit or the fl oor. Just think. The sooner you do this, the sooner Turn six CAM SCREWS (2) into the TOP (A). å...
  • Page 8 Step Step 2 Insert three WOOD DOWELS (3) into the TOP (A). å Fasten the ENDS (B and C) and UPRIGHT (D) to the TOP (A). å Tighten six HIDDEN CAMS. NOTE: Be sure the WOOD DOWELS in the TOP insert into the å...
  • Page 9 Step Step 3 Slide the BACK (E) into the grooves å in the ENDS (B and C) and TOP (A). With the palm of your hand, tap the BACK down into the groove. u r f a i s h e F i n Page 9...
  • Page 10 Step Step 4 Insert three WOOD DOWELS (3) into the ENDS (B and C), å and UPRIGHT (D). Fasten the BOTTOM (F) to the ENDS (B and C), and UPRIGHT (D). å Use six 1-9/16" PAN HEAD SCREWS (11). NOTE: Be sure the WOOD DOWELS in the ENDS and UPRIGHT å...
  • Page 11 Step Step 5 Fasten the BRACES (G) to the BOTTOM (F). Tighten four å 1-3/16" HEX HEAD SCREWS (12) using the L-WRENCH (8). Now might be a good time to refresh NOTE: You should start each SCREW a few turns before å...
  • Page 12 Step Step 6 Fasten a UPPER FRAME (H) to a LOWER FRAME (K). å Tighten four 1/2" HEX HEAD SCREWS (14) using the L-WRENCH (8). NOTE: You should start each SCREW a few turns before å completely tightening any of them. Repeat this step for the remaining FRAMES.
  • Page 13 Step Step 7 Turn the assembly onto its back edges. å Fasten the FRAMES (H and K) to the TOP (A) å and SHELVES (L). Tighten sixteen 1-15/16" HEX HEAD SCREWS (15) using the L-WRENCH (8). NOTE: You should start each SCREW a few turns before å...
  • Page 14 Step Step 8 -Carefully stand your unit upright against the wall in its fi nal location. Strike a mark through the center of the hole in å the UPPER FRAMES (H). Lay your unit down. -Drill a 5/16" hole on the marks. å...
  • Page 15 Step Step 9 Fasten the PULL (4) to the DOOR (J). Use two 3/8" å MACHINE SCREWS (10). If you're doing this to help a friend, don't Fasten the GUIDES to the DOOR (J). Use eight 1/2" FLAT å leave without a bite. HEAD SCREWS (13).
  • Page 16 Step Step 10 NOTE: The UPPER GUIDE (5) tabs should be down before starting this step. å Insert the LOWER GUIDES (6) in the DOOR (J) at an angle into the groove in the BOTTOM (F). Then, tilt å the DOOR (J) up vertically. Push the UPPER GUIDE (5) tabs up into the groove in the TOP (A). NOTE: The DOOR should slide freely in the track.
  • Page 17 Step Step 11 Peel APPLIQUES from the APPLIQUE CARD (9) and stick them onto each visible HIDDEN CAM. å NOTE: Please read the back pages of the instruction booklet for important safety information. å This completes assembly. Clean with a damp cloth. Wipe dry. å...
  • Page 18 WARNING Please use your furniture correctly and safely. Improper use can cause safety hazards, or damage to your furniture or household items. Carefully read the following chart. Look out for: What can happen: How to avoid the problem: • Overloaded shelves. •...