Table of Contents
Advertisement
To service your air filter, place your PECO Pro 12 Aluminum Grass Container in the dump position. Using a 12 mm
wrench, remove the fastener securing the strap that holds the air filter housing in place. Lift the strap and unhook
from the other side. At this point the filter housing should be able to pivot and rotate enough to gain access to the
clasps holding the housing together. Open clasps, remove cover and replace filter if needed. See Figure 2-7b
Figure 2-7b
Strap
Air Filter
12mm
Housing
Fastener
Clasp
2-8 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the Adjusting Screw P#(K1435) and the latch assembly items. To
change the door closure tightness, screw the adjusting screw (Figure 2-8) in or out. To adjust the latch, change the
length of the latch rod by screwing the latch adjusting ball joint in or out. The latch hook pivot should be in the middle
of the slot in the latch hook pivot plate. Slide the pivot back or forth and then re-tighten.
Figure 2-8
Adjustment
Screw
Rue-Ring
Cotter Pin
12
Advertisement
Table of Contents
