Table of Contents
Advertisement
Attach the other end of the latch rod to the lift handle, as shown in Figure 2-6e. Attach on end of the spring
P#(J0176) to the lift handle and the other end of the spring to the handle mount bracket as shown in Figure
2-6f. Adjust the ball joint up or down on the latch rod threads until the latch hook closes completely. After
adjusting the latch hook, secure the latch rod to the lift handle using (1) cotter pin P#(K0094).
Attach Latch Rod
To Lift handle
2-7 Aluminum Grass Container
Installation
NOTE: It is recommended that someone assist in
mounting the container. Lower the container onto the
frame while inserting the Pivot Pins P#(K0172) through
the holes. Insert the pins from the outside to the inside.
Secure with (1) 5/8" Washer P#(K0058) and (1) 5/32" x 2-
5/8" Hair Pin Clip P#(K0088) per pivot pin (Figure 2-7a).
Reattach the bottom ends of the door opening linkages to
the main frame by using (1) Rue-Ring cotter pin
P#(K1437) per side. To test the functionality of the dump
mechanism, pull the lift handle away from the unit, and lift
upward. The door of the container should open and the
box should pivot clockwise towards the ground.
Figure 2-6e
Secure With
(1) Cotter Pin
Figure 2-6f
Attach Spring To
Lift Handle And To
Handle Mount Bracket
Figure 2-7a
Pivot
Pin
Hair Pin
Clip
Washer
11
Advertisement
Table of Contents
