Table of Contents
Advertisement
2-9 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 9 for visual clarification. To change the
door closure tightness, screw the adjusting screw in or
out. To adjust the latch, change the length of the latch
rod by screwing the latch adjusting ball joint in or out.
The latch hook pivot should be in the middle of the slot
in the latch hook pivot plate. Slide the pivot back or forth
and then re-tighten.
2-10 Cam Assembly Adjustment
The cam assembly P#(A0422), which controls the
blower belt tension, comes from the factory pre-
adjusted. If the belt is too tight or becomes too loose,
remove the hair pin clip P#(K0099) from the belt tension
rod P#(K0326) and pull the "L" end of the rod out of it's
hole in the cam assembly. The tension rod may then be
screwed out to tighten the belt or screwed in to loosen
the belt. Replace the "L" end into the top hole in the cam
and replace the hair pin clip. Adjust the cam stop bolt
P#(K1159) to allow the cam to rotate slightly over center
when the blower is engaged (Figure 2-10).
Figure 2-10
Cam
Stop Bolt
Cam Assy.
Tension Rod
2-11 Boot Installation
To mount the boot plate P#(B0079) to the boot
P#(E1030), use (2) 3/8"-16 x 1" carriage bolts P#(K1182)
and (2) 3/8"-16 flange nuts P#(K1215). Make certain that
when bolting the boot and boot plate together, that the
head of the bolt is placed from the inside of the boot.
This will prevent grass from collecting on the bolts. Hang
the boot onto the mower deck, use (Figure 2-11a) for
details. There are slots in the boot plate that will allow for
adjustment left or right to achieve the proper fit for
different size cutting decks. Once the boot is in place
tighten the bolts on the mower deck's deflector shield,
and rotate the deflector against the boot. The deflector
will help keep the boot from moving.
Figure 2-11a
Boot
NOTE: FOR 2007 MODELS
Fasten the boot plate P#(B0435) to the boot P#(E1031)
as described above. Attach the boot plate to the mower
deck using the boot rod P#(B0288). Fasten the boot rod
using (1) hair pin clip P#(K0099). See Figure 2-11b for
reference.
Figure 2-11b
Boot
14
9
Boot Plate
Hair Pin
Boot Rod
Clip
Boot Plate
Advertisement
Table of Contents
