Table of Contents
Advertisement
2-5 Aluminum Grass Container
Installation
NOTE: It is recommended that (3) people assist in
mounting the container.
With three people available, two can lower the container
onto the frame while the third person inserts the pivot
pins P#(K0172) through the holes. Insert the pins from
the outside to the inside. Secure with (1) 5/8" washer
P#(K0058) and (1) 5/32" x 2-5/8" hair pin clip P#(K0088)
per pivot pin (Figure 2-5).
Reattach the bottom ends of the door opening linkages
to the main frame by using (1) Rue-Ring cotter pin
P#(K1437) per side.
To test the functionality of the dump mechanism, pull the
lift handle away from the unit, and lift upward (Page 9).
The door of the container should open and the box
should pivot clockwise towards the ground.
Figure 2-5.
Pivot Pins
2-6 Aluminum Grass Container Inlet
Attachment
The inlet will need to be attached to the container (See
page 9). Open the container, push the inlet from the
inside of the container through the hole in the container
to the outside. Orient the inlet opening to face the
ground. Use the tabs P#(B1668) inside of the box to hold
the inlet in place. It is recommended that two people
perform this step. That way, one person on the inside of
the container can position the tabs, while the other
person tightens the bolts. Looking at the outside of the
container, the most difficult tab to tighten down will be
the tab at the 4-5 o'clock position. Tighten that tab first.
Then proceed to tighten the others.
2-7 Dump Mechanism Adjustment
The linkage may be adjusted in two places, at the
adjusting screw P#(K1435) and the latch assembly
items. See page 9 for visual clarification. To change the
door closure tightness, screw the adjusting screw in or
out. To adjust the latch, change the length of the latch
rod by screwing the latch adjusting ball joint in or out.
The latch hook pivot should be in the middle of the slot in
the latch hook pivot plate. Slide the pivot back or forth
and then re-tighten.
8
Advertisement
Table of Contents
