Table of Contents
Advertisement
2-6 Aluminum Grass Container
Installation
NOTE: It is recommended that (3) people assist in
mounting the container.
With three people available, two can lower the container
onto the frame while the third person inserts the pivot
pins P#(K0172) through the holes. Insert the pins from
the outside to the inside. Secure with (1) 5/8" washer
P#(K0058) and (1) 5/32" x 2-5/8" hair pin clip P#(K0088)
per pivot pin (Figure 2-6).
Reattach the bottom ends of the door opening linkages
to the main frame by using (1) Rue-Ring cotter pin
P#(K1437) per side.
To test the functionality of the dump mechanism, pull the
lift handle away from the unit, and lift upward (Page 9).
The door of the container should open and the box
should pivot clockwise towards the ground.
Figure 2-6
2-7 PTO Handle Installation
NOTE: 2007 And Later Models Only
Fasten the PTO handle P#(A0623) to the PTO assembly
using (3) 1/4"-20 x 3/4" HHCS P#(K1222) and (3) 1/4"-20
nyloc nuts P#(K1128) See Figure 2-7 for reference.
Figure 2-7
(3) 1/4"-20 x 3/4" HHCS
(3) 1/4"-20 Nyloc Nut
2-8 Belt Installation
Loosen the (2) bolts that secure the gear box assembly
P#(A0429) to the pto mount plate (Figure 2-8a). Loosen
the adjustment bolt P#(K0348) until the gear box
assembly is at it's far left adjustment, (the gear box is
moved towards the mower's engine pulley). Connect the
A52K kevlar chord belt P#(M0238) from the engine
pulley to the lower gear box pulley (Figure 2-8b).
To tension the drive belt, turn the adjustment bolt
clockwise until there is 1" of deflection, with 10-11 lbs. Of
pressure between the engine pulley and the gear box
pulley.
Once the correct tension of the belt is achieved, tighten
the (2) bolts that secure the gear box assembly.
Figure 2-8a
Pivot Pins
Figure 2-8b
8
Loosen (2) Bolts
Gear Box
PTO Mount Plate
Gear Box Assy.
Engine Pulley
Adjustment Bolt
Advertisement
Table of Contents
