Table of Contents
Advertisement
BASIC NETWORK
3.
Connection Control: Select the connection control scheme from the list. Options are: Auto-Reconnect
(Always on), Connect-on-Demand, and Connect Manually.
4.
MTU: The default value is 0 (Auto).
5.
NAT: Check to enable. If you enable, there will be no NAT mechanism between the LAN and WAN.
6.
Network Monitoring (keep alive): Monitor WAN interface connection status. As a result, the system can
prevent the WAN connection from auto-timeout and disconnects after a period of inactivity. Check
Enable.
7.
Data Load Check: If there is no data activity on the WAN link for a configured period, it will automatically
reset and reconnect on the mobile WAN link.
8.
Check Interval: Indicate how often to send keep-alive packet or to perform data load check.
9.
Target1/Target2: Set host for keep alive checking including DNS1, DNS2, or Other host (input IP address
manually).
10.
System Watchdog: Monitor overall WAN connection and auto reboot when WAN connection detected
with no reply from keep alive check.
11.
IGMP: Choose to Enable or Disable the IGMP snooping function. When enabled, the device will detect all
IGMP exchanged messages. This prevents multicast flooding on an Ethernet link.
12.
WAN IP Alias: Some ISPs provide a fixed IP address for management purposes. If so, enter this address.
PPP over Ethernet (PPPoE)
Select this option when your ISP requires a PPPoE connection. This is typically used for ADSL services.
1.
IPv6 Dual Stack: Check to enable. Enable this option if your ISP provides one IPv4 and one IPv6 address.
2.
PPPoE Account: Enter the ISP-provided account.
3.
PPPoE Password: Enter the ISP-provided password.
4.
Primary DNS: Enter the primary DNS IP Address.
5.
Secondary DNS: Enter the secondary DNS IP Address. Can be left blank if your ISP doesn't supply one.
6.
Connection Control: Select the connection control scheme from the list. Options are: Auto-Reconnect
(Always on), Connect-on-Demand, and Connect Manually.
7.
Service Name: Your ISP may provide you with a specific service name when connecting with PPPoE.
8.
Assigned IP Address: Your ISP may provide you with a fixed IP address for this type of connection.
9.
MTU: The default value is 0 (Auto).
10.
NAT: Check to enable. If you enable, there will be no NAT mechanism between the LAN and WAN.
11.
Network Monitoring (keep alive): Monitor WAN interface connection status. As a result, the system can
prevent the WAN connection from auto-timeout and disconnects after a period of inactivity. Check
Enable.
12.
Data Load Check: If there is no data activity on the WAN link for a configured period, it will automatically
reset and reconnect on the mobile WAN link.
13.
Check Interval: Indicate how often to send keep-alive packet or to perform data load check.
14.
Target1/Target2: Set host for keep alive checking including DNS1, DNS2, or Other host (input IP address
manually).
15.
System Watchdog: Monitor overall WAN connection and auto reboot when WAN connection detected
with no reply from keep alive check.
16.
IGMP: Choose to Enable or Disable the IGMP snooping function. When enabled, the device will detect all
IGMP messaged exchanged. This prevents multicast flooding on an Ethernet link.
20
®
MultiConnect
rCell 500 R2 Series Router User Guide
Advertisement
Table of Contents
