Table of Contents
Advertisement
BASIC NETWORK
Authentication Type
WPA2 (802.11x)
WPA-PSK/WPA2-PSK
WPA/WPA2 (802.11x)
STA Isolation: Enables or Disables to isolate the Wi-Fi clients that are connected to VAP.
Broadcast SSID: Enables or Disables to broadcast or hide SSID.
Enable: Enables or Disables VAP.
Wireless Client List
The Wireless Client List displays the connected wireless clients. Choose to see all connected clients or only clients
on a specific AP.
Advanced Configuration
Advanced wireless setup is used to optimize the wireless performance under the specific installation environment.
1.
Operation Band: Select 2.4G or 5G Wi-Fi band.
2.
Beacon Interval: Beacons are broadcast packets that are sent by a wireless AP/router.
3.
DTIM Interval: Delivery Traffic Indication Message Interval. When the wireless router has buffered a
broadcast or multicast message for clients, it sends a DTIM with a DTIM interval value.
4.
RTS Threshold: Adjust the Request to Send Threshold value and you can improve wireless performance if
there is an excessive number of wireless packet collisions.
5.
Fragmentation: Wireless frames are divided into smaller units to improve performance in the presence of
RF interference.
6.
WMM: Wi-Fi Multimedia helps control latency and jitter when transmitting multimedia content over a
wireless connection.
7.
TX Rate: Choose Best for auto-adjustment based on Wi-Fi signal quality in the current environment.
8.
RF Bandwidth: Choose Auto for auto bandwidth or set fixed bandwidth to HT20 or HT40
9.
Transmit Power: You can lower the power ratio to prevent transmissions from reaching beyond your
corporate/home office or designated wireless area.
IPv6 Setup
IPv6 is a version of the Internet Protocol (IP) intended to succeed IPv4. IPv6 implements additional features do not
present in IPv4. It simplified aspects of address assignment, network renumbering, and router announcements.
This device supports Static IPv6, DHCPv6, PPPoE, 6 to 4, and 6 in 4 connection types. Confirm with your ISP what
type of IPv6 is supported before you proceed with IPv6 setup.
Note:
IPv6 isn't supported when WAN type is 3G/4G.
26
Description
In this mode, specify the IP address and port number for the RADIUS server. The key
value is shared by the device and RADIUS server. The available encryption modes are
TKIP, AES , or TKIP/AES.
This mode is used when some clients only support WPA-PSK and others use WPA2-
PSK. You don't need an additional RADIUS server for user authentication.
This mode is used when some clients only support WPA and others use WPA2. The
key value is shared by the device and RADIUS server. Specify the RADIUS server IP
address and port number.
®
MultiConnect
rCell 500 R2 Series Router User Guide
Advertisement
Table of Contents
