Table of Contents
Advertisement
a.
Physical Interface: Indicate which 3G/LTE modem is used for network scan. SIM Status indicates
which SIM card is used for Network Scan.
b.
Network Type: Set network scan type. You can choose 2G only or prefer, 3G only or prefer, LTE only
or prefer, or Auto.
c.
Scan Approach: Choose Auto, or Manually. If you choose Manually, click Scan to scan cellular
network nearby and select your network provider. Click Apply.
Note:
Incorrect settings may cause 3G/LTE connection problems.
Internet Setup for Ethernet WAN
1.
To access Ethernet WAN settings, click Internet Setup.
2.
Click Edit next to the Ethernet WAN you want to configure.
3.
WAN types available are Dynamic IP, Static IP, PPPoE, PPTP, and L2TP.
Static IP
Use this option if your ISP provides a fixed IP address. Enter the ISP-provided IP address, subnet mask, and gateway
address. The device rejects IP addresses that are not in the correct format.
1.
WAN IP Address: Enter the provided IP Address.
2.
WAN Subnet Mask: Enter the provided subnet mask.
3.
WAN Gateway: Enter the provided gateway address.
4.
Primary DNS: Enter the primary DNS IP Address.
5.
Secondary DNS: Enter the secondary DNS. This can be left blank if your ISP doesn't supply one.
6.
MTU: The default value is 0 (Auto).
7.
NAT: Check to enable. If you enable, there will be no NAT mechanism between the LAN and WAN.
8.
Network Monitoring (keep alive): Monitor WAN interface connection status. As a result, the system can
prevent the WAN connection from auto-timeout and disconnects after a period of inactivity. Check
Enable.
9.
Data Load Check: If there is no data activity on the WAN link for a configured period, it will automatically
reset and reconnect on the mobile WAN link.
10.
Check Interval: Indicate how often to send keep-alive packet or to perform data load check.
11.
Target1/Target2: Set host for keep alive checking including DNS1, DNS2, or Other host (input IP address
manually).
12.
System Watchdog: Monitor overall WAN connection and auto reboot when WAN connection detected
with no reply from keep alive check.
13.
IGMP: Choose Enable or Disable the IGMP snooping function. When enabled, the device detects all IGMP
exchanged messages. This prevents multicast flooding on an Ethernet link.
14.
WAN IP Alias: Some ISPs provide a fixed IP address for management purposes. If so, enter this address.
Dynamic IP
To configure a Dynamic IP the following fields are available:
1.
Host Name: This field is optional. It may be required by some ISPs.
2.
ISP Registered MAC address: Enter the registered MAC address or click Clone to copy your PC's MAC
address.
®
MultiConnect
rCell 500 R2 Series Router User Guide
BASIC NETWORK
19
Advertisement
Table of Contents
