Table of Contents
Advertisement
BASIC NETWORK
a.
To use this function, check Enable.
b.
Enter the IP address for two LAN devices.
c.
Enter the Time interval.
d.
Click Save.
VLAN
The VLAN function allows you to divide a local network into virtual LANs. In some cases, the network needs
multiple LANs with support certain services. This device supports port-based VLAN and tag-based VLAN. Select
either operation mode and configure accordingly.
Port-Based VLAN
A port-based VLAN is a group of ports on an Ethernet switch or router that form a logical Ethernet segment. This
device supports four LAN ports and up to eight virtual APs. By default, all LAN and virtual APs belong to one VLAN.
This VLAN is a NAT network, all local device IP addresses are allocated by DHCP server 1. To divide them into
different VLANs, click Add next to the port you want to configure.
1.
VLAN ID: Enter unique VLAN ID from 6 to 4091.
2.
VLAN Tagging: Enable or Disable VLAN Tagging with outgoing data.
3.
Type: Select NAT or BRIDGE to identify if the packets are directly bridged to the WAN port or processed
by a NAT mechanism.
4.
Port Members: Check the desired ports to be part of the VLAN.
5.
LAN to Join: Select preconfigured DHCP server to be used by the VLAN.
6.
WAN & WAN VID to Join: Specify the WAN links to be used by the VLAN.
7.
Configure DHCP server information: Enter DHCP server information such as Server Relay, Server Name,
IP Pool, Lease Time, Domain Name, Primary DNS, Secondary DNS, Primary WINS, and Secondary WINS.
8.
Enable: Enables or Disables this VLAN.
Tag-Based VLAN
In a tag-based VLAN, groups which have assigned tags and ports are no longer specifically assigned. To configure a
tag-based VLAN, click Add to create a new VLAN to setup.
1.
VLAN ID: Specify this group's VLAN tag. Enter unique VLAN ID 6 to 4091.
2.
Internet Access: Check to enable internet access.
3.
Port: Check the desired ports to be part of the VLAN.
4.
DHCP Server: Specify a preconfigured DHCP server that VLAN will get its IP addresses."
Port Speed
The port speed function configures the Ethernet ports to a fixed speed.
1.
Speed Mode: Select Auto, 10, 100, or 1000 for the Ethernet ports.
2.
Duplex Mode: Select Auto, Half, or Full duplex for the Ethernet ports.
Port Setup
The port setup function configures the Ethernet ports to be enabled/disabled.
Enable / Disable: Select Enable or Disable for the Ethernet port.
24
®
MultiConnect
rCell 500 R2 Series Router User Guide
Advertisement
Table of Contents
